Thingiverse
Bltouch mount Infitary M508
by Royco2
23
Downloads
16
Likes
0
Makes
Minor tweak to orginial Prusa i3 Hephestos BLTouch Auto Leveling Mount.
The mount was to high for the infitary m508, so i added a little bit of material for height (about 5.7mm) so it falls into the Bltouch 8mm difference in height between nozzle and bottom of bltouch (Not including metal pin).
For more information on how to setup the BLtouch on a Infitary prusa I3 m508, go here;
http://bizinno.blogspot.co.nz/2017/07/setting-up-bltouch-on-infitary-m508.html
The mount was to high for the infitary m508, so i added a little bit of material for height (about 5.7mm) so it falls into the Bltouch 8mm difference in height between nozzle and bottom of bltouch (Not including metal pin).
For more information on how to setup the BLtouch on a Infitary prusa I3 m508, go here;
http://bizinno.blogspot.co.nz/2017/07/setting-up-bltouch-on-infitary-m508.html
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!