BLTouch Sensor Mount - Geeetech G2S Pro Mini

Here is a mount to install a BLTouch Auto Leveling Sensor on a Geeetech G2s Pro Mini. It replaces and uses the existing location and bolts of the stock leveling switch. You'll need a couple M3x20mm bolts with nuts to secure the sensor to the mount. You'll also need extra cabling to run the connections from the probe to the GT2560 board and once there do a bit of soldering to connect them. The three servo pins from the BLTouch (orange, red, and brown) will need to be soldered to the GT2560, but the switch pins (black, white) are crimped to female connectors and connect to the Z-Min connector on the board. For a schematic of where to solder the servo pins, see the attached picture above.

The offsets for Configuration.h in Marlin are as follows:

X_PROBE_OFFSET_FROM_EXTRUDER -41.2
Y_PROBE_OFFSET_FROM_EXTRUDER -10.70
Z_PROBE_OFFSET_FROM_EXTRUDER -0.90

Tweak the Z_PROBE_OFFSET for your setup as needed of course and consult the great BLTouch Google Plus group for all other configu