BLTouch Sensor Mount - Geeetech Rostock 301

Here's a BLTouch Sensor Mount for a Geeetech Rostock 301 mixing printer. The default GTM32 controller does not support auto leveling, but other controllers do. I retrofitted my 301 with Duet WiFi/Duex 5 electronics and a BLTouch and viola! A delta diamond hot end printer with auto-leveling! The mount installs at the rear of the effector. For reference, the probe tip is located at an offset of X=0.00, Y=-45.50, and Z=0.30 from the nozzle. Your Z will vary with your setup somewhat. I've included my config.g, bed.g, and the system macros for deploying, retracting, and reseting the BLTouch for reference if you're using Duet electronics.

You can find the Duet WiFi and its distributors at http://www.duet3d.com

Update 9-28-17: I created Duet macros for the BLTouch and to help in the printer calibration process and I've uploaded them.

Update 10-18-17: Version 2 of the mount has been uploaded! I revised the original design to include some important improvements. First, I imp