Thingiverse
Blue Vase/Lamp
von JobSmolders
89
Downloads
89
Likes
0
Makes
This Lamp began as a test Vase to be honest. I wanted to test a new printer and this “Vase” was one of the Test models I made. I liked it so much that I turned it into a Lamp.
To do this I made a simple “ base “. There are 2. The one I used is “base 6mm.stl”, but If you want to scale down, “base 21mm.stl” might be better (In the “base” is a small cavity where the connector of the LED strip is housed. If you scale down the base to much, this cavity might become to small for the connector).
The (in Translucent Blue PET-G) Printed Vase sits on this Base. Then in the Vase an Aluminum tube is bolted down using an M4x40 bolt, nut and printed parts “tube plug lamp.stl”. An LED strip (15meters) is wrapped around this tube, making the light source. To get a better the idea how this all comes together, please see the Photos in the Photo section.
The Aluminum tube I used is 490mm high and has an outer diameter of 34mm.
The Lamp Shade (or Vase) is 558.7mm high. Yes I had to scale it down
To do this I made a simple “ base “. There are 2. The one I used is “base 6mm.stl”, but If you want to scale down, “base 21mm.stl” might be better (In the “base” is a small cavity where the connector of the LED strip is housed. If you scale down the base to much, this cavity might become to small for the connector).
The (in Translucent Blue PET-G) Printed Vase sits on this Base. Then in the Vase an Aluminum tube is bolted down using an M4x40 bolt, nut and printed parts “tube plug lamp.stl”. An LED strip (15meters) is wrapped around this tube, making the light source. To get a better the idea how this all comes together, please see the Photos in the Photo section.
The Aluminum tube I used is 490mm high and has an outer diameter of 34mm.
The Lamp Shade (or Vase) is 558.7mm high. Yes I had to scale it down
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
