Bluetooth Speaker ND65 2.5"

I wanted to build my own Bluetooth speaker so i designed this myself.

It prints really easy but can take some time. It took about 20 hours total to print the lid and the speaker box.

i printed with no supports, but the top of the speaker hole is slightly stringy, but it looked good enough for me so you can print without supports if you would like.

I designed it for Dayton Audio ND65-8 2-1/2" speakers.

Parts list: (adjust as desired)

Note: If you are patient you can buy a lot of these parts on Ali-Express and save a lot of money. i bought most of them on amazon though.

Speaker Drivers
https://www.parts-express.com/dayton-audio-nd65-8-2-1-2-aluminum-cone-full-range-neo-driver-8-ohm--290-206

Bluetooth Amplifier:
https://www.amazon.com/gp/product/B01I9KV7F4/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1

Battery Management Board: (protect and balance battery cells during charging)
https://www.amazon.com/gp/product/B0711J3PBR/ref=oh_aui_detailpage_o01_s00?ie=UTF8&