Thingiverse

BME 280 - desktophousing

von Modellaner

24 Downloads

22 Likes

0 Makes

I've created this small housing for a BME280 combo sensor. It is made to put it on indoor tabletops but it should work in normal outdoor conditions too.

you will also need:

- 4* M3 nuts

- 2* M3 x 36 mm screws

- 2* M3 x 6 mm screws

- 2* M3 x 10 mm screws

- maybe a little bit glue to fix the nuts in position

- cable min. 4 lines (for I2C) or 6 lines (for SPI)

arduino BME280 BME280 housing BME280 sensorholder esp32 ESP8266 sensor weather station arduino BME280 BME280 housing BME280 sensorholder esp32 ESP8266 sensor weather station

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

aufwändige Nachbearbeitung

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 2/3

Drucker