Thingiverse
BMG Knob Knob
von Mikael70
5
Downloads
2
Likes
0
Makes
This is for a DotBit knob. I guess it fit other BMG versions as well. Put some Tipp-Ex in the slot.
* Clear marking that you can feel with your fingers.
* Easier to turn.
* Optional magnet so you doesn´t loose the spring or washer
*Note:*
Use one more one turn than usual because of the extra torque and better grip. I use 3 turns for PLA and ABS. Too much pressure result in less torque for pushing filament. To little and the filament slip.
*Requirements:*
M3 washer (not stainless steel)
Optional dia4x3 (530g) magnet or similar*
Tipp-Ex or other paint.
* Clear marking that you can feel with your fingers.
* Easier to turn.
* Optional magnet so you doesn´t loose the spring or washer
*Note:*
Use one more one turn than usual because of the extra torque and better grip. I use 3 turns for PLA and ABS. Too much pressure result in less torque for pushing filament. To little and the filament slip.
*Requirements:*
M3 washer (not stainless steel)
Optional dia4x3 (530g) magnet or similar*
Tipp-Ex or other paint.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
