MakerWorld
Decor
Go to Model
BMW E28 wall art
23
Downloads
7
Likes
8
Makes
A beautiful piece of wall art displaying the BMW E28 in all of its glory. Print it face down or face up, depending on your preferred surface finish and build plate. Can be mirrored to allow for both left-hand and right-hand drive versions. Resolution: 0.2mm layer heightInfill: Not requiredBuild adhesion type: None requiredSupports: Not neededThickness: 1.4 mm - can be decreased but thinner than 1mm will likely be too fragile.Size: The model can be scaled to your required size, but be careful with the thin areas as they might become too thin to print.Boost MeYour support is greatly appreciated ❤️
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
