BMW i3 Faceplate DTC button

This is a faceplate for a BMW i3 where the DTC button was retrofitted from a BMW i8. The existing faceplate misses the hole for the DTC button.

Made with ASA for higher car temperatures, the clips on the side are a little bit thicker to prevent easy breaking. It's a little bit tight during installation, but feasible.

I used 260 degrees C, 100 degrees C for the bed, slow print, 0.15 mm layer height and a little bit overextrusion of 3-5% for better layer adhesion.

I enclosed the Freecad file, so you can easily adapt any changes.

Have fun!