Thingiverse
BNC Housing
by BP_685
8
Downloads
3
Likes
0
Makes
Housing designed to connect a BNC to wire.
1) Run wire through body from outside to inside.
2) Tie a knot in wire or use a cable tie as strain relief.
3) Tighten BNC onto cap.
4) Make solder connections.
5) Use glue on inside of body where cap will fit.
6) Pull wire out to till it stops.
7) Press cap into place.
8) Let dry.
1) Run wire through body from outside to inside.
2) Tie a knot in wire or use a cable tie as strain relief.
3) Tighten BNC onto cap.
4) Make solder connections.
5) Use glue on inside of body where cap will fit.
6) Pull wire out to till it stops.
7) Press cap into place.
8) Let dry.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!