Thingiverse
Bo Katan V5
by Bozzy1979
225
Downloads
150
Likes
5
Makes
V5 Of my Bo katan after some feedback from makers.
1. the band around the back in 10mm wider
2. the vents are smaller creating a thicker boarder.
3. i've made a hole in the helmet for the stalk and created a bulge in the ear cap so a M4 bolt can be used with a washer and butterfly nut to keep tension on the stalk allowing you to freely move it.
PLEASE USE THE V6 found in my designs . It's a much more accurate helmet.
1. the band around the back in 10mm wider
2. the vents are smaller creating a thicker boarder.
3. i've made a hole in the helmet for the stalk and created a bulge in the ear cap so a M4 bolt can be used with a washer and butterfly nut to keep tension on the stalk allowing you to freely move it.
PLEASE USE THE V6 found in my designs . It's a much more accurate helmet.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
