Thingiverse
Board Game Spinner Arrow
von MRKPMNTL
78
Downloads
70
Likes
1
Makes
Needed a board game spinner replacement. At 100% this clocks in just over 8cm / 85mm which is perfect for the Peppa Pig Chutes and Ladders game I needed it for. Its not too flimsy for toddlers and little ones and doesnt have any sharp/pointy edges.
Printed using PLA on low quality settings in Cura.
Layer Height: 0.28mm
Infill Density: 20%
Infill Type: Cubic
Took about 18 minutes based on my settings and printer.
Printed using PLA on low quality settings in Cura.
Layer Height: 0.28mm
Infill Density: 20%
Infill Type: Cubic
Took about 18 minutes based on my settings and printer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
