Boardgame Riser

For those that don't have the space or just need to raise up their board games a little higher to allow for beverages to be out of the way or cards or dice, etc... This is for you.Each gameboard riser is 150mm X 150mm.This is designed to be modular, so you can use 3x2 (450mm x 300mm) pattern or 3x3 (450mm x 450mm) pattern but with fewer boards, you may need a few more legs for it to remain stable. The leveling feet shouldn't be necessary unless you're going for more height. If that's the case, print them at a slightly smaller tolerance(99 - 95%). The pegs are designed to fit in the recessed angle and glued. Once dried, you can then fit it into the protruding section of another riser board for a snug hold.You can use some Neodymium magnets, 3x8's I believe(they may be a tight fit) in place of some of the pegs to create the attraction to each other. If you do, you can use 2 pairs on each outer edge with matching recessed and protruding section of each riser board. If