Thingiverse
Boat Shuttle Weaving
por RobinB87
15
Descargas
30
Likes
0
Makes
To hold a bobbin of weft during weaving.
Consists of two parts, the BODY and the ROD.
The ROD slides completely in and out of the BODY, to hold and release the bobbin.
There is a slat of wood adhered to the bottom of the BODY in the images, though this should not be nessecary for function.
The rod has diameter 4mm
The bay has length 148mm and width 34mm
The yarn slit has width of 5mm
The ROD is a cylinder with ends cut to match the BODY where they exit, and a segment cut from the bottom to print on.
Consists of two parts, the BODY and the ROD.
The ROD slides completely in and out of the BODY, to hold and release the bobbin.
There is a slat of wood adhered to the bottom of the BODY in the images, though this should not be nessecary for function.
The rod has diameter 4mm
The bay has length 148mm and width 34mm
The yarn slit has width of 5mm
The ROD is a cylinder with ends cut to match the BODY where they exit, and a segment cut from the bottom to print on.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
