Bob-Omb Tissue Holder

This is a remix of the Bob-Omb Tissue Holder I found on here recently:

https://www.thingiverse.com/thing:442257

I liked the idea but wanted to change a few things about the body so I completely recreated it in Fusion 360. I also added a screw at the back. Basically all files have been recreated or adapted from the original to fit the changes.

Depending on your result the upper and lower body might not hold together strong enough to pull tissues out. I added some quickly designed interlocking hinges, which you can glue to the inside. That should hold everything in place.

Measurements: 17cm wide x 25 cm deep x 17 cm high

Printed on Anycubic Kobra using Anycubic and Overture PLA Filament