Boc's Lightsaber

Boc Aseca's lightsaber from Jedi Knight: Dark Forces II

There's not a lot of reference material to speculate its design. So this model is a combination of ideas from many makers on what it may have looked like.

Boc used 2 lightsabers that locked together and could be separated to use individually.

No clip for this one. Boc strapped his lightsaber on his back using a leather holster.

I haven't 3d printed the pieces yet so some tampering may be needed to make it run smoothly.

The emitter fits a 1" blade and has a lip further down to stop it going all the way through the tube.

Since there are 2 sabers you will need to print everything twice with exception to the Choke/Lock you would need to print 4x.

For one saber:
Print Choke1 x2
Print Lock1 x2

The locks was designed for me to have one saber to hold 6mm Neodymium magnets and the other sabers locks to hold 6mm steel rods that protrude into the opposite lock for a strong hold that could still repeatably be taken