Body with better support

I had some difficulties printing the body due to some of the small supports needed. My problem was that the supports would not stick to the plate as well as the they should in this design and adding a raft was not possible because of my bed plate size . I added a small layer in the open areas at the same level as the first layer that would serve as a base for my supports and it worked better for me. this layer is only 0.4 mm thick (what my printer considered layer 1) and can easily be taken off similar to a support, but may need some sanding on the edges . There has been no overall design change to the body but it now has less chance of the print dislodging from the plate. If you are having difficulties printing this large part similar to what I did hopefully this will help.

I have also added the first layer of the original part so that if necessary you know where to remove the pieces that are from my design. simply print this layer and use it as a guide to remove the supports I ha