Bodykit d12

This is a bodykit i made for my d12.

its made in such a way that you dont have to modify anything on the stock car, it just bolts on

the rear bumper have screwholes but they are not needed because it snaps in over some studs in the back. (be careful, measure width so you know it fits your car first)

the sides glues together with the rear bumper and to the bodymounts. what i did was i mounted the rear bumper, and the bodymounts to the car, Then i glued the side to the rear bumper together, after that i glued the side to the bodymounts, this way i could ensure good fitment between car and sides.

the front just screws right in.

see pictures for screw points and glue points, also see pic for suggested print orientation.

use finest possible print setting (ofc) and use supports for all parts except bodymounts. the rear bumper has an angle on the underside, use "lay flat" feature in your printing software.

happy printing. if you are wondering about the mirrors and the