Thingiverse
Bog plant pot
von les_kaye
39
Downloads
42
Likes
0
Makes
Pitcher and Bog Plant Pot
====================
Plant pot for pitcher and other bog plants which like to stand in an inch of water. A one piece design of pot and water tray. It is best to spray-paint your pot as it may leak between the print layers.
This is a large print 255mm x 155mm x 170mm high but should scale successfully to other sizes.
The corrugated design is to reduce warping and cracking in ABS but I recommend that you use PLA or PETG which has better layer adhesion and reduced warping.
====================
Plant pot for pitcher and other bog plants which like to stand in an inch of water. A one piece design of pot and water tray. It is best to spray-paint your pot as it may leak between the print layers.
This is a large print 255mm x 155mm x 170mm high but should scale successfully to other sizes.
The corrugated design is to reduce warping and cracking in ABS but I recommend that you use PLA or PETG which has better layer adhesion and reduced warping.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
