BoltStand SmatPhone (beta)

Having a support for the SmartPhone is usually useful, the objective was to be able to vary its inclination using simple elements, after giving the idea many thoughts, I opted for an M6x80 screw with a 1 mm pitch in the thread, one of the most common on the market, as part of the mechanism. The route after tests in the drawing program would be enough to vary the inclination between 30° and 85° (plus degree, minus degree)

The concept is simple (I think), a sliding piece that houses a nut changes the inclination, turning the screw transports the piece that raises the inclination of the bed of the device.
The pieces did not require much rectification, printed at 0.20 (layer height), a file review of the screw hole so that it rotates freely, perhaps a little sanding of the piece that houses the nut in its base to give a good clearance to the assembly if you feel it forced when assembling it and not much else. The piece that acts as a wheel to rotate the mechanism is threaded under pres