Bondtech BMG Creality Mount (For Locknuts)

Updated Bytespider's original design to make enough room for locknuts to hold the bracket onto the extruder mounting plate. Can still be used with normal nuts if needed. The pockets are loose enough that nuts will fall out, so a dab of glue or tape over them can hold them in place better. The stepper motor will hold the locknuts in place, so this is optional.

I also closed in the open section as I didn't like being able to see through to the stepper motor.

---

**Installation Process:**

Insert Locknuts into recessed pockets.
Align BMG and Stepper Motor (Note: Stepper wire connection must be facing away from Lead Screw).
Use long BMG screws to attach Stepper Motor and BMG Extruder to bracket.
Use four M3x8mm screws to attach bracket to Extruder mounting plate.


---

**Requirements:**

4 x M3 8mm bolts.
4 x M3 Nuts/Locknuts


---

Like my design or found it useful? Consider leaving a tip or buying me a [Ko-fi](http://ko-fi.com/aussiemaker).