Thingiverse
Bone clip bag
by WMard1
1
Downloads
0
Likes
0
Makes
Print in two pcs. For connect slightly use small hammer or clamps
the material is PLA printed on a 0.6mm nozzle, it turned out quite well, of course, 0.4mm will be a better effect.
30% fill is ok, could be bigger and stronger.
the material is PLA printed on a 0.6mm nozzle, it turned out quite well, of course, 0.4mm will be a better effect.
30% fill is ok, could be bigger and stronger.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
