Bookmark, Eye, Hueforge

You do not need an AMS to change colours. At the layer where you should change colour, change to pause and manually change the colour when the print pauses. Bookmarks need a clean plate to avoid any corners rising. Project: eye.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 46.5x140mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 1.3mm and the Actual Depth is 1.4mm Filaments Used: PLA Generic Black PLA Generic Brown PLA R3D Red PLA BambuLab Generic WhiteThis print uses 4 unique filaments Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Brown At layer #10 (0.88mm) swap to Red At layer #11 (0.96mm) swap to White for the rest. Boost Me