Thingiverse
Bookmark - Happy Life
par Tori68
3
Téléchargements
3
Likes
0
Makes
This is a Bookmark for reading books.
Support is required.
I recommand 0.1mm Layer & 100% infill printout for smooth surface. (above pictures were made under 0.2mm, so rough)
Be careful when you take out the printout, as the letters are prone to breakage. If you are using glue on the bed, you can soak it in a little water around the prints and carefully remove it after a minute.
Support is required.
I recommand 0.1mm Layer & 100% infill printout for smooth surface. (above pictures were made under 0.2mm, so rough)
Be careful when you take out the printout, as the letters are prone to breakage. If you are using glue on the bed, you can soak it in a little water around the prints and carefully remove it after a minute.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
