Thingiverse
Bookshelf end
por pvsfair
4
Descargas
3
Likes
0
Makes
Does not need supports!!!
==============
> Only bridging on the top part
I printed with 25% infill with giroid infill, so it is stronger, but even with 15% it would be fine. 25% was too much...
==============
> Only bridging on the top part
I printed with 25% infill with giroid infill, so it is stronger, but even with 15% it would be fine. 25% was too much...
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
