Thingiverse
Boom arm wall mount
5
Downloads
3
Likes
0
Makes
Instead of buying a wall mount for my Neewer microphone boom arm I decided to quickly sketch one in fusion. Hole is under sized
I didn't put holes on the wings so you can drill them any size you want.
Drill out the center hole to a half inch hole size for it to fit best with the boom arm. The retention screw hole is optional, I placed my microphone above my setup so I do not need it but it is there for anyone who does. Drill it out to size and thread the nut in.
Print infill from 40-100% up to you, i did 65% seems to work at .2mm layer height
Update 4/11/22: Mount arms finally broke on me, edited file to make them thicker. Would recommend higher infill.
I didn't put holes on the wings so you can drill them any size you want.
Drill out the center hole to a half inch hole size for it to fit best with the boom arm. The retention screw hole is optional, I placed my microphone above my setup so I do not need it but it is there for anyone who does. Drill it out to size and thread the nut in.
Print infill from 40-100% up to you, i did 65% seems to work at .2mm layer height
Update 4/11/22: Mount arms finally broke on me, edited file to make them thicker. Would recommend higher infill.
lonewolfsstuck also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
