Thingiverse
Boosted V2 - MRE Race Caps
by Rand0000
12
Downloads
12
Likes
0
Makes
These are simple motor caps for boosted v2, they are cut way back for a few reasons:
- Quick belt change/replace - only skate tool, no hex key req.
- Cut back allows OVER 97mm wheels w/o rub (Should fit 100mm & 110mm - NOT TESTED)
- Why not? A peak of the motor gear is kinda cool
The cap still guards the motor gear and a large portion of the belt.
The pictured cap was printed in ABS then sprayed w/plastidip
- Quick belt change/replace - only skate tool, no hex key req.
- Cut back allows OVER 97mm wheels w/o rub (Should fit 100mm & 110mm - NOT TESTED)
- Why not? A peak of the motor gear is kinda cool
The cap still guards the motor gear and a large portion of the belt.
The pictured cap was printed in ABS then sprayed w/plastidip
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
