Boot, Hat, Mitten Dryer

This is a drying rack for boots, hats, mittens, etc. that fits over floor air vents up to 6 in x 12 in (150 mm x 300 mm) with threaded drying tubes that are 6 in (150 mm) tall. The base is flared out at the bottom to help reduce tipping when heavy boots are place on the rack. A model for a plug is also included in the print profile for those that don't need eight drying tubes. The plugs and tubes are threaded into the base plate, so the rack layout can be customized to your need and also disassembled for easy storage at the end of the season. Filament Selection (PLEASE READ!):The filament you select needs to be sufficient for the temperature of the air coming through your vent. From my research, air temperatures can go as high as approximately 60C (140F) for gas and oil heating forced air systems. For these systems, you should avoid PLA since it has a typical maximum use temperature in 50-60C (122-140F) range, and use something like PETG, ABS or ASA that all have typical use temper