Thingiverse
Borescope Mount for Hangtight Duct
door ProfEngr
3
Downloads
3
Likes
0
Makes
Recently started seeing people post about using USB borescopes to watch the nozzle lay down the first layer (or watch the thing work its magic remotely). Figured I'd whip up something simple to hold the one I had handy. The hole is 5.8mm diameter.
Two STLs are available:
The mount block itself so you can adjust it for best position before gluing to Hangtight's duct.
The block attached to the duct to print as one piece. The geometry I used to make the hole is centered on the nozzle tip.
My scope had other plans and needed adjustment of the block for a good view so I didn't reprint the duct.
Two STLs are available:
The mount block itself so you can adjust it for best position before gluing to Hangtight's duct.
The block attached to the duct to print as one piece. The geometry I used to make the hole is centered on the nozzle tip.
My scope had other plans and needed adjustment of the block for a good view so I didn't reprint the duct.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!