Thingiverse
Borg Cube
von Geoschatter
1
Downloads
0
Likes
0
Makes
From Star Trek, this is a Borg Cube with internal light and rotating.
https://www.youtube.com/shorts/lGwXIpFvbWw
https://www.youtube.com/watch?v=JcUZShOoEis
To print the CubePannels, set the layer height to 0.1 mm and use transparent filament for the first 5 layers, then switch to gray filament to print the rest of the panels.
To print the PedestalPannels, set the layer height to 0.1 mm and use the same color filament as used for the PedestalFrame for the first 5 layers, then switch to yellow / blue filament to print the rest of the panels.
https://www.youtube.com/shorts/lGwXIpFvbWw
https://www.youtube.com/watch?v=JcUZShOoEis
To print the CubePannels, set the layer height to 0.1 mm and use transparent filament for the first 5 layers, then switch to gray filament to print the rest of the panels.
To print the PedestalPannels, set the layer height to 0.1 mm and use the same color filament as used for the PedestalFrame for the first 5 layers, then switch to yellow / blue filament to print the rest of the panels.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
