Bosch 12v charger multiboard mount

I have reverse-engineered the bottom plate of the Bosch 12v charger and made a 15degrees angled multiboard adapter so the batteries can charge nicely without the risk of falling out. It needs a moderate load and standard snap, but these are modified as well as they take a countersunk M4 screw from the ‘back’, i.e. the nut is held within the mount, and screw goes through the snap. This was necessary as the back plate needs to be installed first on the charger, then screw in the snaps and push on the multiboard. Hardware required:2x M4 countersunk screws - 12-14mm2x M4 nuts The plate is attached to the charger using stock screws. Check out my other designs for the multiboard: Bosch 12v Battery mount Bosch 18v Battery mount Deburring Tool holder<figure class="image