Bosch GO 2 base

Hi!
I made my own version of the base for the Bosch GO 2 electric screwdriver. The screwdriver can be positioned vertically or horizontally. Also, the bits and screwdriver are fixed to the base tightly enough to be used during transport.
In the bit storage compartments, I installed the 2.9 mm diameter ball magnets that I had in stock. Each cell has two such magnets. The magnets are easily pressed into place one by one.
You can use your magnets in other sizes by changing the model . I attach the Fusion 360 project.
You can also use this base without using magnets.
If you are going to use magnets, it would be worth going through the bit holes with a 7.5 mm drill to make it easier to remove the bits. Be sure to drill AFTER installing the magnets in the cells, so as not to damage the model. It is better to do it manually, without using a drill.
If the drill does not pass, the cells will be dense enough that the bits do not fall out even without magnets.

24 magnets with a diameter