Thingiverse
Bosch Kiox300 protection
door Theduck38
24
Downloads
33
Likes
1
Makes
Facing the lack of 3D models for the new Bosch Kiox300, I decided to make it by myself...
Here's the result.
This is the 5th evolution, starting with a model with very sharp angles, to finish with a smoother one.
Beware : the protection is not (vertically) symmetrical, as the Kiox. The two short sides (up and down when you look at it) are not the same in terms of angle and size. So be careful not to reverse it when you put the Kiox inside !
Here's the result.
This is the 5th evolution, starting with a model with very sharp angles, to finish with a smoother one.
Beware : the protection is not (vertically) symmetrical, as the Kiox. The two short sides (up and down when you look at it) are not the same in terms of angle and size. So be careful not to reverse it when you put the Kiox inside !
Theduck38 publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
