Bose A20 Control Holder

This is a sleek holder for the control module on the Bose A20 aviation headset.

The module slips in from the top and is held perfectly. It is tight enough to hold the controller but not so tight it leaves scratches, there is enough room to put in some electrical tape or thin felt for padding if wanted.

There is no hole for mounting because I have had better luck just heating up a screwdriver and poking a hole through wherever it is needed. I mounted this in my aircraft by removing one screw for the interior trim under the storm window and simply meeting a hole in the print where it fits best, then screwed it back in.

Print vertically to reduce chances of layer separation during use.