Bose QC35II Stand

This is the MakerBot headphone stand I modified specifically for Bose QC35 II headphones.

EDIT:
Version 2 is posted. It is still printable on the Ender 3; you must print it lying on its back, diagonally across the print bed, and with "None" under "Bed Adhesion" in CURA. I printed without supports as the overhangs do not exceed 70 degrees, and my Ender 3 can handle that.
Changes:
- It is now 215 mm from where the band rests to the desk(previously 193mm)
- The band-rest fits the QC35II's slightly better
- I added a 10mm slot on the bottom for a charge cable(I recommend one with a 90 bend, as its a bit of a tight fit.