Bottle Clip
door strex
79
Downloads
44
Likes
1
Makes
Water bottle clip, designed to secure a standard water bottle to the webbing on a backpack shoulder strap, or belt. Similar to "Aqua Clip". This is the third revision, as I've managed to remove extra, unneeded material, and shave off a few grams; while still retaining rigidity. The textured finish on the clip (from 3D printing) adds a bit of security, so it doesn't slide out of the shoulder strap so easily, when bending over. I'd also recommend dipping the end of the clip in some kind of "rubber dip" for more security.
Edit: v2 Recreated from the ground up. Should be a lot more substantial.
For the gram weenie's out there:
Total weight, of printed clip (in PLA): 4 grams
v2 Total weight, of printed clip (in PLA): ?
Constructive feedback welcome!
No affiliation with Aquaclip, Aquaclip and Aquahook are registered trademarks used by GJC Products, Inc. under license. All rights reserved.
Edit: v2 Recreated from the ground up. Should be a lot more substantial.
For the gram weenie's out there:
Total weight, of printed clip (in PLA): 4 grams
v2 Total weight, of printed clip (in PLA): ?
Constructive feedback welcome!
No affiliation with Aquaclip, Aquaclip and Aquahook are registered trademarks used by GJC Products, Inc. under license. All rights reserved.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
