Thingiverse
bottle draining holder
door uzosan
13
Downloads
8
Likes
0
Makes
Some water bottle just need to drain before be reuse. That is a way that can preventing falling.
"top" and "bottom" can be printed without support. The sticks maybe printed without support, too. But it very depends, how your material glues on the printing area. I printed my sticks with a little bit support only at the very end of every stick ending. See picture. Worked fine.
"top" and "bottom" can be printed without support. The sticks maybe printed without support, too. But it very depends, how your material glues on the printing area. I printed my sticks with a little bit support only at the very end of every stick ending. See picture. Worked fine.
uzosan publiceert ook op
20 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
