Thingiverse

bottle drying stand 3 leg

door staypatrick

12 Downloads

10 Likes

0 Makes

I love the original design but I felt I was wasting too much plastic on this. I designed a 3 leg version to save from printing 1 arm on the base. I will be printing this soon but I am sure it will be fine. i made sure the tolerances of .6 is the same across the board. I cut out one of the holes with tinkercad then filled in another so it held 0 legs. Then added that hole into the blank spots. Turned out quite nice. Legs are at 29 mm and inside is 29.6800 at the widest point.

beer beer bottle beer brewing bottle brew brewing brewpi Brewster drink homebrew homebrewing home brew home brewing stand beer beer bottle beer brewing bottle brew brewing brewpi Brewster drink homebrew homebrewing home brew home brewing stand

Bron

Thingiverse

Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid

Eendelig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 0/3

Printer

FDM / FFF

Bestandsformaat