Thingiverse
Bottle Opener
von TimLParis
17
Downloads
6
Likes
0
Makes
A bottle opener modeled after the GrabOpener http://gropener.com/
One side for bottles, one side for cans.
Don't try to sell this as they have a patent on the design.
Printed in PLA, has held up just fine, just need to make sure it is fully engaged on the bottle cap.
Pointer finger goes in the hole, and the little hook goes under the middle finger.
One side for bottles, one side for cans.
Don't try to sell this as they have a patent on the design.
Printed in PLA, has held up just fine, just need to make sure it is fully engaged on the bottle cap.
Pointer finger goes in the hole, and the little hook goes under the middle finger.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
