Thingiverse
Bottle Pourer
by whowhatwhere
65
Downloads
61
Likes
0
Makes
One of those cute little things you put in bottle of vinegar/soy sauce/cooking oil/etc to allow you to pour evenly without the "gluging and spilling".
It has a tapered bottle stopper with 2 channels through it's centre One to let fluid out and the other to let air in.
I suspect that the ridges wont seal very well (partly because ABS is quite a hard plastic and partly because I have made then quite thick. However it would not take much to put a rubber washer on it to give it a good seal and hold it in place.
It has a tapered bottle stopper with 2 channels through it's centre One to let fluid out and the other to let air in.
I suspect that the ridges wont seal very well (partly because ABS is quite a hard plastic and partly because I have made then quite thick. However it would not take much to put a rubber washer on it to give it a good seal and hold it in place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
