Thingiverse
Bottle Rack
von bogrole
4
Downloads
14
Likes
0
Makes
A bottle rack sized to fit 1L spirit bottles, so reduce in size for wine.
Prints with no supports, best to print joining pieces with long edge on the base for additional strength.
If you perfer the nut and thread (and screw heads) on each end then print 2 fronts instead of a back.
Used Exoxy to bond together and very solid, I used PETG and 5 walls, 50% infill.
If you are going for the same look, I sprayed in black, then a light dusting of copper spray before laquer.
Prints with no supports, best to print joining pieces with long edge on the base for additional strength.
If you perfer the nut and thread (and screw heads) on each end then print 2 fronts instead of a back.
Used Exoxy to bond together and very solid, I used PETG and 5 walls, 50% infill.
If you are going for the same look, I sprayed in black, then a light dusting of copper spray before laquer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
