Bottle Tripod

EN
I constructed this thing with Fusion 360 because the thing I specified as the remix basis didn't work as expected.
On the one hand, the lid does not have a screw cap for the drinking bottle, but is only attached to the lid of the bottle.After to the printout, it was far too big and didn't hold up. On the other hand, the cross-shaped pin on which you were supposed to attach or screw the camera also had no thread and was much too small.
So I tried with the 1/4" threads present in the Fusion 360 and an added PCO1881 Bottle thread to make this Bottle tripod screwable. Until I realized that the Fusion thread didn't fit. After some research, I found out that a 1/4" thread is not automatically a 1/4" thread, but can vary greatly. There is a 1/4"-16 with 16 pitches as stored in Fusion 360 and there is the photo thread 1/4"-20. So I created this thread as a database and integrated it into Fusion. You can download the XML file for 1/4"-20 and 3/8"-16 here.
Please exercise caution when uns