Thingiverse
Bowden Deflector
by dassmilytier
6
Downloads
8
Likes
0
Makes
update 25.06.2016:
I uploaded a second version for those of you that did the ball-joint upgrade. The upgrade is definitly worth it, but the original problem with the bowden still persist. so here is a slightly modified versions so the pins will be at the correct positions.
I had a tiny problem with my orion delta from SeeMeCNC. The bowden was not straigt and tend to get stuck on top of the rear carriage, especially for larger prints, that uses all the area. Therefor I now created a deflector that is attached to the right arm of the rear carriage.
The new version contains a rounded bed to better fit to the carriage. Also the cable tie holder is now open for easier attachment
I uploaded a second version for those of you that did the ball-joint upgrade. The upgrade is definitly worth it, but the original problem with the bowden still persist. so here is a slightly modified versions so the pins will be at the correct positions.
I had a tiny problem with my orion delta from SeeMeCNC. The bowden was not straigt and tend to get stuck on top of the rear carriage, especially for larger prints, that uses all the area. Therefor I now created a deflector that is attached to the right arm of the rear carriage.
The new version contains a rounded bed to better fit to the carriage. Also the cable tie holder is now open for easier attachment
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
