Bowden Flex M6 remix

My son busted the PC4-M6 bowden tube holder while assembling our new Anycubic Kossel, ordered a replacement, in the mean time imported these two items into tinkercad,put a light bevel on the input side of the tube holder screwon, then joined the two and trimmed here and there...what you see is the result...printed on my Anet A8 for my new Kossel works quite well actually!

I did have to take a drillbit (by hand) a little smaller than the bowden tube and clean out a little bit of extrusion that didn't stick. but once clean filament feeds just fine and it holds the tube very snugly

-edit- 02/24/3018 fixed the taper thru the body, no longer have to worry about it hanging up (there was a tiny lip in the original design) fixed the cap as well for some reason it was hollow between the threads and grip...repaired, ready to go