Thingiverse
Bowden tube bracket
5
Downloads
5
Likes
0
Makes
----Update 3.23.22--- it finally broke. updated to direct drive. worked for thousands of hours.
----Update 5.9.19-- last revision. I have been using this for almost 100 hours of print and have a pretty good feeling about it. **BUT** I had to feed the tube through this bracket and then I pushed the end of the tube up the nozzle after turning it up to 270.. in turn it has flared the end of the tube and it doesn't move at all. let me know your experiences.
I've designed a bowden tube bracket because I was tired of being worried about the bowden brass fittings. print at >50% infill to make it sturdy. needs supports and to be printed with the bowden hole at the top like shown in the STL photo.
**recommended and tested with PLA ONLY**
**You will need extended screws to mount it back on**
.SLDPRT included as well. enjoy
----Update 5.9.19-- last revision. I have been using this for almost 100 hours of print and have a pretty good feeling about it. **BUT** I had to feed the tube through this bracket and then I pushed the end of the tube up the nozzle after turning it up to 270.. in turn it has flared the end of the tube and it doesn't move at all. let me know your experiences.
I've designed a bowden tube bracket because I was tired of being worried about the bowden brass fittings. print at >50% infill to make it sturdy. needs supports and to be printed with the bowden hole at the top like shown in the STL photo.
**recommended and tested with PLA ONLY**
**You will need extended screws to mount it back on**
.SLDPRT included as well. enjoy
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
