Thingiverse
Bowser Turtle Mode Fin
von hirnschaden
11
Downloads
19
Likes
0
Makes
This is my first try of creating an unique turtle fin for my 5" Quad.
I ripped the shell off bowsers back and designed the two antenna holders for TBS Immortal-T and an AXII or similar (17mm) into it.
Mounting holes from the top fit 30.5x30.5cm stack size holes on any topplate.
Since I designed this one to use on my Potzblitz Infinitum there are for cutouts for mounting the topplate screws.
Additionally I uploaded the solid shell part for your own remixes..
Happy printing!
I ripped the shell off bowsers back and designed the two antenna holders for TBS Immortal-T and an AXII or similar (17mm) into it.
Mounting holes from the top fit 30.5x30.5cm stack size holes on any topplate.
Since I designed this one to use on my Potzblitz Infinitum there are for cutouts for mounting the topplate screws.
Additionally I uploaded the solid shell part for your own remixes..
Happy printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
