Thingiverse
Box for electronics with KFB 2.0
di u-maker
11
Download
2
Likes
0
Makes
Box for electronics with KFB 2.0
Installation is assumed on one of the sidewalls.
The halves are connected with four screws M3x25 with nuts.
The board is mounted with M3x10 screws with nuts and washers.
The number of fans in the upper half is optional. Fastening - M3x16 screws with nuts and washers.
The necessary holes are drilled, cut, break out.
The height of the layer is 0.16 mm.
The nozzle is 0.4 mm.
The print speed is 50 mm / s.
Plastic - ABS.
Filling - 100%.
Installation is assumed on one of the sidewalls.
The halves are connected with four screws M3x25 with nuts.
The board is mounted with M3x10 screws with nuts and washers.
The number of fans in the upper half is optional. Fastening - M3x16 screws with nuts and washers.
The necessary holes are drilled, cut, break out.
The height of the layer is 0.16 mm.
The nozzle is 0.4 mm.
The print speed is 50 mm / s.
Plastic - ABS.
Filling - 100%.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
