Thingiverse
Box in two halves
13
Downloads
5
Likes
0
Makes
Designed this box to practice the 3D modeling of moving parts.
It measures 10cm x 7cm x 5cm of height (two halves of 2.5cm each) and the walls have a thickness of 2mm.
I made it so it needs almost no supports. You will have no waste of material, but I consider them to be necessary inside the hinge part, if you set it to generate supports over 80° you wont have unnecessary supports in other places.
It measures 10cm x 7cm x 5cm of height (two halves of 2.5cm each) and the walls have a thickness of 2mm.
I made it so it needs almost no supports. You will have no waste of material, but I consider them to be necessary inside the hinge part, if you set it to generate supports over 80° you wont have unnecessary supports in other places.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
