Box with sliding lid.

Hello!
I made this box with a slide lid to store stuff in.
You can have this on your desk, or in a drawer or wherever you want it.

I designed this in Tinkercad and then i used PrusaSlicer to export the gcode.
The lid only took one hour, 20 minutes but the box takes 8 hours and 40 minutes.
I had to grind on the sides of the lid to make it fit a little bit better.

the handle on the lid is on one of the short sides. (depends on how u want to have it.)

the dimensions on the box are the following
height: 66 mm
depth: 108 mm
width with lid: 165 mm
width without lid: 152 mm

the dimensions on the lid are the following.
height: 2 mm
depth: 102 mm
width: 160 mm

if you want to make this box smaller or bigger you can but remember to make the lid the same scale as the box. (unless you want to have it some other way.)

I hoped you liked this box and if you want to see stuff made by me, keep checking in on my profile. :)