Thingiverse
BP-511 Connector
von Tig29
11
Downloads
7
Likes
0
Makes
A useful connector for a BP-511 Battery, takes less than 20 mins to print (0.3mm, 20% fill). The contacts are some 0.6mm solid hook up wire.
I produced this to allow me to charge some batteries where I'd lost the original charger but it would allow you to power other items with these ubiquitous batteries.
I produced this to allow me to charge some batteries where I'd lost the original charger but it would allow you to power other items with these ubiquitous batteries.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
